Residential only
Gas, electric, tankless and heat-pump water heaters, replaced and installed for houses in Tacoma, Parkland, Spanaway, Lakewood, Puyallup, University Place and the surrounding Pierce County communities. Same approach as the rest of our work: look at what the house actually needs, explain the practical options, and let you choose without a commissioned salesperson in the middle.
A straightforward like-for-like tank swap is still the right answer in plenty of homes, especially when the existing fuel, venting and space all work. What matters is correct sizing for how the household actually uses hot water, proper venting and combustion air on gas units, and code items such as expansion control, seismic strapping and a safe pan and drain arrangement.
Heat-pump water heaters use a fraction of the energy of a standard electric tank, which makes them a strong fit for garages, utility rooms and daylight basements in this climate. They need adequate air volume around them, a workable condensate path, and the right electrical circuit — so we check those before recommending one rather than after.
Tankless makes sense when you want continuous hot water and the space back, but it is not automatically the better buy. Gas capacity, venting routes, electrical requirements and how many fixtures run at once all decide whether it will actually perform in your house. We'll tell you when a tank is the smarter build.
We handle water heater replacement and installation as part of our residential mechanical work — not general plumbing service, remodels or repiping. Permitting is handled as required for the project, and where electrical or other licensed trades are needed we use trusted licensed, bonded and insured subcontractors.
Pricing follows an on-site evaluation — fuel type, venting, electrical, access and location change the job enough that flat published numbers would be misleading. Where efficiency incentives exist, we can help you identify what you may qualify for; eligibility varies and we don't promise rebate amounts.
Common questions
Start with the basics: for gas units, confirm the thermostat/pilot setting and that you don't smell gas; for electric, check the breaker. Look for obvious leaks or water pooling around the tank. If you smell gas, leave the house and call your gas utility from a safe location. Beyond those simple checks, most no-hot-water calls need a diagnostic visit to find the real cause safely.
It depends on how your household uses hot water, the available fuel, existing venting, electrical or gas capacity, and space. Tankless units deliver continuous hot water and free up floor space, but they are not automatically the lower-cost or better-performing choice. A standard tank can still be the smarter build when venting, gas line size, or electrical service is limiting. We size the option to the house, not to a sales target.
Often yes, especially in garages, utility rooms, and daylight basements where there is enough surrounding air volume and a workable condensate drain path. The mild Pacific Northwest temperatures help, but the space and electrical circuit have to match. We check those details before recommending one rather than after the install.
We handle water heater replacement and installation as part of our residential mechanical work. Some problems can be repaired, and when a repair is the honest answer we will say so. When replacement makes more sense, we explain why and let you choose the practical option. We do not offer general plumbing service, remodels, or repiping.
Permitting is handled as required for the project. Water heater replacement and installation stays within our residential mechanical scope; we do not present it as broad plumbing work. Where electrical or other licensed trades are needed, we use trusted licensed, bonded and insured subcontractors.